KNOWLEDGE

Home/KNOWLEDGE/Details

Bearing installation and removal

How to Install and Removal Bearings

Preparation before installation:

1. The installation of the bearing needs to be carried out under dry and clean conditions.

2. Before installing the bearing, it is necessary to prepare and clean the surface of the installation tool.

3. Before installation, carefully check the mating surface of the shaft and the housing, and confirm in advance that there is no damage, indentation, burrs, etc.

4. When the installation work is not completed, do not unpack the bearing to avoid pollution.

Bearing installation:

1. Pressure method:

The method of installing directly by pressure without changing the size of the matching parts under normal temperature conditions is called the pressure method. This method is generally used for the installation of small and medium-sized bearings with small interference. However, this method should be avoided for large or large bearings and parts with weak rigidity to prevent deformation of related parts.

(1) When the inner ring of the bearing is tightly fitted with the shaft and the outer ring is loosely fitted with the housing, the bearing should be installed on the shaft first. Remember: the bearing needs to be evenly stressed during installation.

1 

(2) The outer ring of the bearing is tightly fitted with the bearing seat hole, and when the inner ring and the shaft are loosely fitted, the bearing can be pressed into the bearing seat hole first. Remember: the bearing needs to be evenly stressed when it is pressed in.

1 

(3) If the inner and outer rings of the bearing sleeve are tightly fitted with the shaft and the seat hole, the inner and outer rings should be pressed into the shaft and the seat hole at the same time during installation.

3

2. Temperature difference method:

When the interference is large or the bearing needs to be assembled and disassembled frequently during use, it is easy to damage the mating surface when the bearing is assembled and disassembled by pressure. At this time, the temperature difference method can be considered for installation. The temperature difference method is to use the heating (expansion) or cooling (contraction) method to temporarily disappear the bearing interference, and restore it to the normal temperature to achieve the purpose of light installation and removal of the bearing.

3. Hydraulic method:

Hydraulic installation of bearings is a relatively advanced method. The principle is to use high-pressure oil to pass through the pre-machined oil holes and oil grooves, enter the interference fit of the bearing to form a high-pressure oil ring film, and use the tension of the high-pressure oil to expand the matching surface for installation.

4 

Bearing removal:

1. Percussion method: The bearing is removed by using the impact energy generated when the hammer hits the copper rod or soft iron.

2. Drawing method: The drawing method should be used for bearing parts with high precision that are not allowed to be knocked. It uses a special puller for disassembly.

5

3. Temperature difference method: The temperature difference method is to use the thermal expansion and contraction performance of the material to heat the inner part, so that the fitting part loses the interference under the condition of temperature difference and realizes the disassembly. Generally, a special electric heater matched with the bearing is used.

4. Hydraulic method: The hydraulic method is a principle to disassemble and install the bearing.


Previous: No Information
Next: No Information